3D Printed Snow Blower

[moo10032]

I'm trying to get my project kickstarted. It is a 1/10th scale 3d printed snow blower. It is powered by a standard 540 sized motor and uses standard RC servos to raise and lower the whole snow blower. Also a servo is used to turn the shoot that directs the snow. It can plow through 14 x 5 inches of powdered snow in one pass!

https://www.kickstarter.com/projects/moospyker/3d-printed-rc-snow-blower-2nd-generation

https://imagizer.imageshack.us/v2/880x660q90/913/I2JrKt.jpg

[JDH429]

Top notch work! Always wanted to build one myself. You have quite the setup there. Hope you reach your goal.

[Brel]

now that is really cool (if you pardon the pun LOL)

[Themonty73]

Excellent adaption any videos of this throwing snow???
Keep up the great work

:jaw:

[moo10032]

Couple vids of it here, sorry for the late reply.

https://www.youtube.com/watch?v=c0xcDeq9GaY

https://www.youtube.com/watch?v=tJIGZgeJn9k

[JCLARE248]

Very nice engineering and build!!

[moo10032]

I have re-launched the 3d Printed Snow Blower kickstarter! Being so much closer to winter this should make it now!
https://www.kickstarter.com/projects/moospyker/3d-printed-rc-snow-blower

[bigford]

neat blower

[Acadieman]

Its very nice! My tractor is too small at the moment, working on making a bigger tractor. :)

[1985 kenworth]

that is so cool ..

[andyathome]

I wish it snowed here, then I would have a reason to do another job around the house with an RC machine.

very cool

cheers andy

[Northern Farmer]

Nice Blizzard looks good with the blower on there! Does the design work well ? I've keeping up on another forum about this mod. Guy is currently designing his own "Blizzard" vehicle powered by two 540 motors..quite curious to see his working prototype when complete :cool: