1/16 John Deere 9620rx

[davaante25]

This is my work in progress 1/16 John Deere 9620rx.

[davaante25]

My current progress.

[davaante25]

More Progress

[davaante25]

Here Is my test drive

https://www.youtube.com/watch?v=ZEiO40EgnL4

[up9018]

Looks really good and seems to be a smooth operation. Nice job.

Chris

[davaante25]

Thank you

[Grainfarmer]

Nice conversion! Runs pretty good...

[Rvjimd]

Looks nice, do you have a big disc or plow or planter to pull behind?

How was the conversion?

Jim

[davaante25]

Thank you. I don't have any implements at the moment. I plan the get the 1/16 Lemken Air Drill Solitair 9, or the 1/16 John Deere Disc 637 Flex Fold, and install firgelli actuators on them to make them functional. The build took about a week and 1/2 to finish. I would say that the hardest parts were cutting out the idler wheels, and making the main drive wheel compatible to the axle shafts. It doesnt have a good turning rate. That's the down side, its turn wide. I now have to fit the main drive wheels with teeth to catch the tracks a little better to reduce slipping when pulling.

[Themonty73]

Hi,

What make is this model that's converted? Would love to have a go and converting one.

Thank you

:bounce:

[davaante25]

Its an Ertl 1:16 scale John Deere 9620rx

[Dblrflach]

What kind of Axles drivelines and transmission did you use?

[skeeter]

A nicely done conversion!

[rc13]

What kind of Axles drivelines and transmission did you use?

Yes what did you use for the trans.? When I first watched the video, it sounded and looked to me that you had a motor for each track. But then I saw the pics of the single motor, trans, and the driveshafts.
That drive motion is very tight. No play. I like it. That will fair well for more precision.

[davaante25]

I used a Rc4wd R2 BLACK CRAWLER TRANSMISSION V2, two Tamiya King hauler axles, Rc4wd punisher drive shafts.

[rc_farmer]

Did you do a Case 620 conversion?