TLT Axle Question

[sparkycuda]

I've read the thread on Front Axle Options and it is full of great info. Current project - IH 350 Payhauler - has been delayed slightly to consider an alternative front axle size. I bought the RC Channel standard width axles based on truck measurements taken off a photograph. Now that the frame is built, the axle measurements were a bit off - I could make the RC axles work but would have to recess the spindle deep into the back of the wheel assembly - with possible steering knuckle interference.

:confused:So the question: what is the kingpin to kingpin distance on TLT axles? Total axle width is good, just need to know where the kingpins would be.

Thanks!

Ken

[Car5858]

5.4085 in 137.38mm

2.8265 from pinion cp to left kp

2.5820 from pinion cp to right kp

HTH

[sparkycuda]

:)Thanks for the quick response! This helps with my decision about which axle to go with.

Ken