6T pinion gear

[roadranger]

OK guys, I've been hunting around for a 6T pinion gear with no luck.
Anyone got an internet source for them??

Also, the Tamiya gearbox is 32 pitch, correct?

Thanks for any help!

[Vanisle]

Not sure where you can buy a pinion gear that small but you can buy 6t pinion wire from Stock Drive Products:

https://sdp-si.com/eStore/

Go to "Gears" and then "Pinion Wire"

You need to know the pitch and pressure angle. For approximately $15 you can get 1 foot of brass pinion stock that you can cut pinion gears from on a lathe. Obvously you would need a lathe and way to make the hole/keway.

The price adds up quickly because their shipping rates aren't that great and they have a handling fee.

[firefighter30]

Try rc4wd.com

[Vanisle]

Try rc4wd.com

Ya, that's easier:

http://store.rc4wd.com/6-Tooth-32-Pitch-Hardened-Steel-Pinion-Gear_p_610.html

[roadranger]

Thanks guys!

I tried a search on RC4WD, and all I came up with was an 8 tooth... don't know why...

[sig p232]

Contact hooters chassis http://www.angelfire.com/pa/hootchas/

I just looked, I dont know what happened to my 6t, but pullers tend to use them quite a bit.

Nate

[Tamiya Cowboy]

Here is the link to the ones I get off RC4WD

http://store.rc4wd.com/6-Tooth-32-Pitch-Hardened-Steel-Pinion-Gear_p_610.html

[Juganought]

@ Tamiya Cowboy... Do you have to make any adjustments to make it fit? After waiting impatiently for almost two weeks, I bought the wrong one off Rc4WD, Thick I am:D

[civicex5speed]

So TC, the Tamiya spure Gear is a 32 pitch? Do you know if the 3 speed from the F350 is also 32 pitch? It appears to be, I can say it's NOT 48 or 64 pitch.

LMK

[Tamiya Cowboy]

Yes it is the same pitch as the semi tranny..