PDA

View Full Version : Turnigy 9x for dozer questions


baker3
12-20-2013, 10:45 AM
Anyone using this radio with info is greatly appreciated. I am trying to mix channels to control all steering and throttle from the left stick. I have my ESC's for the two servos plugged into the CH1&2. So far I can get both tracks to move forward and back but unable to steer. Any help? I am a complete noob to this area

doodlebug
12-20-2013, 02:09 PM
The only suggestion I have is to use a Sabertooth controller, they have the mixing built in,
http://www.dimensionengineering.com/products/sabertooth2x5rc Hope somebody else will chime in too!
Cheer's, Neil.

Lil Giants
12-20-2013, 03:16 PM
Your radio came with a manual, did it not? Look under channel mixing. ;)

Tip: the throttle channel is Master and the steering is Slave. It'll be +100 & -100.

I've never owned a Turnigy radio. For my Spektrum radio, if it's steering the wrong way, then I can either switch the + & - values or reverse the travel of steering ch itself.

kenobi
12-20-2013, 06:01 PM
This may be of help, there are tons of them on YouTube
http://youtu.be/YNx9DHySD9A

doodlebug
12-20-2013, 07:39 PM
TURN ON RADIO
go to display. using your display find out which stick operates your
RUDDER AND ELIVATOR. Change stick type till you get then where you want them.
Go to V-TAIL
State = ACT
ELE1 = -100
ELE2 = 100
RUD1 = 100
RUD2 = -100

Go back to display and watch how they work.

Cheers Chris.

HMMMMM! all this programing makes my radio a dinosaur :lol::lol::lol:
Cheer's, Neil.

baker3
12-28-2013, 05:42 PM
TURN ON RADIO
go to display. using your display find out which stick operates your
RUDDER AND ELIVATOR. Change stick type till you get then where you want them.
Go to V-TAIL
State = ACT
ELE1 = -100
ELE2 = 100
RUD1 = 100
RUD2 = -100

Go back to display and watch how they work.

Cheers Chris.

I tried what you said and I still cant get it. I have the left track running off channel 2, Right track off channel 3 and the rams are controlled with the Rudder and Aileron. Do I have to plug the tracks into an Aux slot?

Brel
12-28-2013, 06:11 PM
have look at this forum http://openrcforums.com/forum/index.php (you may have to register) they have lots of stuff on there about the 9X radio

kaptain Jack
12-29-2013, 08:57 AM
That's not exactly what you looking for,but still can be usefull
http://www.youtube.com/watch?v=Oi7jRcsfXB8

baker3
12-29-2013, 10:24 AM
So for anyone having similar troubles, I finally figured it out. I have my radio set to "acro". I then set the stick type to the Rud and Ele to use channels 2 and 4 which my tracks are plugged into. Then as Oztruck said, go to V-Tail and adjust the parameters to what he said.