PDA

View Full Version : Sabertooth 2x12 RC problem


buzzy16
04-09-2014, 08:49 AM
Hi, I have a problem with the sabertooth 2x12 RC that's in my dunp truck, I have the drive motor on he motor 2 on the sabertooth and the motor for the screwdrive is on motor 1, everything works fine apart from the screwdrive only down at a fraction of the speed as going up. I have tried changing the travel and the trim on my controller but it doesn't change anything. I have the motor on the 3 pos switch on my dx8.

I was hoping someone would be able to help me.

thank, you i advance.

buzzy

trucker n
04-09-2014, 11:23 PM
So are your EPA the same on the 3pos switch u might want to look at your manual for the radio

buzzy16
04-13-2014, 02:41 AM
Hi Buzzy.

Get in touch with dimension engineering direct, They are good to deal with any problems you are having, they helped me out.

http://www.dimensionengineering.com/

Regards Ralph P.S. Do you ever get over to Victoria ?

So are your EPA the same on the 3pos switch u might want to look at your manual for the radio

Thanks guys, I fixed the problem, turns out I had to have one of the switches down for it to find neutral.

And not really Ralph, I really should there are a few of you guys popping up in Victoria and even WA, it's a shame there's no one around my area.