Turnigy receiver controlled switch
 

Hi All, i need help
how to wiring Turnigy receiver controlled switch,
i follow the menu to wiring, but not work:confused::confused:

Re: Turnigy receiver controlled switch
 

Best I remember the switch has to have the same ground as the receiver ,try that a nd maybe someone else will chime in . I am using these to turn on a motor on my belt drive with no issues. When i first out it in i was using two batteries and once i got the 2 grounds together it worked fine,then later went to a single battery and still works like a charm. Hope this helps:)

Re: Turnigy receiver controlled switch
 

if you are using two batteries like in the pic you must have a common ground as specified in the included data sheet

Re: Turnigy receiver controlled switch
 

Look at the files on the hobbyking page. there is a wiring diagram as a part of the manual that shows a couple different ways of using these.

http://hobbyking.com/hobbyking/store...d_Switch_.html