Suitable gear mesh
1 Attachment(s)
Hello all; I’m at the motor mounting/motor audjusting state and I’m wondering what is a suitable gear mesh for the main drive train? Here is what I have now and I can slide a piece of printer paper through easily enough but not too easy
|
Re: Suitable gear mesh
:thinking::confused::(Can anybody see that picture?? I did as directed but I feel it’s not working…
|
Re: Suitable gear mesh
HI
No I cannot see the picture try again please |
Re: Suitable gear mesh
2 Attachment(s)
How’s this
|
Re: Suitable gear mesh
WTH? It’s not working when I want to post a pic?
|
Re: Suitable gear mesh
1 Attachment(s)
Test
|
Re: Suitable gear mesh
Basically you just want a very little amount of play. If they are tight it will cause premature wear and excessive motor load. Too loose and premature wear quicker. A piece of paper cut close to same width of gear then ran between gears is basically what I do. Newspaper is thin, printer paper should do. Sandwiche it between gears tighten up and rotate it out.
https://youtu.be/xFGy8RARHN4 |
Re: Suitable gear mesh
Ok, will do. I already put the printer paper through it and it went through cleanly. Not too loose, and not too tight.
|
Re: Suitable gear mesh
Cool! Just did as your video said. That helped a lot, thanks!
|
All times are GMT -4. The time now is 03:28 PM. |
Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.