help!!!!!
 

ok i got my tipper trailer convert to hydrauilc. i got a new pump for the excavator, from mangom hrc. and so i pu the old one in the tipper. but i dosn'e sem to want to lift the bed right?

if i give it a little bump it will lift but from fully down i dose semt to want to do it? what going on? here a vid of what i mean.
http://www.youtube.com/watch?v=0g6m2...ature=youtu.be

Re: help!!!!!
 

looks like the angle is to low for the cylinders to start the lift
almost looks like there trying to push the box to the rear instead of up

Re: help!!!!!
 

ok got it to work but now need more lifting power. any idea?

Re: help!!!!!
 

If you still need more lifting power then the angle and placement of your cylinders is still not right. If the angle and placement is right it should lift a good amount even at low pressure. Here is how you can mount that long of a cylinder and make it work with a good bit more power.

http://i574.photobucket.com/albums/s...psab0fb995.jpg

Travis

Re: help!!!!!
 

hmmm . so it need more angle? wow! i drilling holes all in the trailer. will fix

Re: help!!!!!
 

Yes the more angle you can get the better it will work.

Travis

Re: help!!!!!
 

well after playing it all day this is what i came up with.
http://www.youtube.com/watch?v=7SuAz...ature=youtu.be

Re: help!!!!!
 

That looks a lot better. Have you tried it with some weight in the trailer?

Travis

Re: help!!!!!
 

ya there is still a sticking point. if i get i passed that i will tip about anything but anything really heavy i doesn't like . im thinking its the pump. it was old that's way i got a new one for the excavator

Re: help!!!!!
 

Try using some heavy weight oil and see what happens. It may slow the pump down but it should help the psi some.

Travis

Re: help!!!!!
 

well its the pump, i hooked up my other pump just to see if it was better and wow! ya like four times the power. so i got to save up few 100$ dollors to get a new one

Re: help!!!!!
 

parts to fix the pumps on there way.