GMC PD4501
 

im not sure if this is the place to ask,,or should it be in the builders section?

but here i go..ive decided on two long term builds..a set of double bottom dumps,pulled by a single axle tractor.

and two is a GMC PD 4501 (Greyhound Scenicruiser)..here my question,on the PD 4501,would it be better to build a skeleton type frame work? ,or carve a master "plug" from some sort of soft (workable?)wood? and maybe fiberglass the mold?..or use it to form brass or copper sheet?..

but if i did the plug,and fiberglass..i guess id have to make a mold on the plug,then turn it over and fiberglass the inside to make the detail ect correct?...

gosh i dont know what would be harder..

http://i1248.photobucket.com/albums/...ps2f724e9c.jpg

Re: GMC PD4501
 

Is this close to what ur are planning to build? Pics are from when I made them

http://i17.photobucket.com/albums/b7...8/100_0176.jpg

http://i17.photobucket.com/albums/b7...100_0184-1.jpg

Re: GMC PD4501
 

yes sir..thats them...i always enjoyed watching them on jobsites

Re: GMC PD4501
 

Pm sent