Logging Cab Guard
 

Hi all

here is my plan for an Aluminium Logging Guard for my current Build

I will route the uprights from 32 X 3 flat and use 7mm tubing for the outer section and 5mm tubing for the inner bars.

Two spot lamps from a 4x4 will be used on the two small brackets at the top.

it will sit on two 20 X 12 angle that will slit between the fuel tank brackets.

a piece of 10 X 15 channel with a section slotted out will sit on top of the uprights, this is where the trailer will rest when on the back of the truck.

http://i206.photobucket.com/albums/b...k/CabGuard.jpg

Re: Logging Cab Guard
 

All the pieces are made, now just to ali solder them together.......never done this before so I hope it goes ok :)

http://i206.photobucket.com/albums/b...140817_002.jpg

http://i206.photobucket.com/albums/b...140817_001.jpg

Re: Logging Cab Guard
 

Very nice.