PMD's Dump Conversion Kit for King Hauler
 

Does anybody have any experience with PMD's Dump Conversion Kit for King Hauler?

I figure since I don't have any metal forming experience (or tools) that this would be a good introduction to the world of hydraulics.

Re: PMD's Dump Conversion Kit for King Hauler
 

Its basicly built to be a strait forward operation. The cylender is veary simple, and easy to figure out.

Re: PMD's Dump Conversion Kit for King Hauler
 

Is the thing able to have a full load put into it and dump it without any real issues?

Re: PMD's Dump Conversion Kit for King Hauler
 

The answer is No.

The info with the kit says it is dual voltage - 7.2v or 12v. This is only true with an empty truck. Even then, 11.1v will raise the bed in 30 seconds, while 7.4v takes 60 seconds.

With a full load of dirt and rock, with full meaning nothing higher than the sides, 11.1v will raise the bed in 50 seconds. 7.4v will only raise the bed half way and takes 90 seconds to do that.