RC Truck and Construction - Search Results

		RC Truck and Construction > Search Forums
Search Results

Showing results 1 to 5 of 5
Search took 0.00 seconds. Search: Posts Made By: CustomRCmodels

Forum: Mechanical tech

03-02-2013, 02:37 PM

Replies: 76

Sticky: Driven front axle options?

Views: 95,109

Posted By CustomRCmodels

Re: Driven front axle options?

The fronts line up with the outer rears . Its just an illusion from the angle how that photo was taken . For a better comparison here with a King Hauler body :
all-wheel-drive rig , but with bigger...

Forum: Mechanical tech

03-02-2013, 02:26 PM

Replies: 76

Sticky: Driven front axle options?

Views: 95,109

Posted By CustomRCmodels

Re: Driven front axle options?

If you get 2x TLT-1 axles and 2x center axles ( from a 3 axle truck ) , then you have all the parts for the swap without having to purchase the extra axle housing ( a-parts 0005467 + pinion-gear ) ,...

Forum: Mechanical tech

03-02-2013, 02:13 PM

Replies: 76

Sticky: Driven front axle options?

Views: 95,109

Posted By CustomRCmodels

Re: Driven front axle options?

As for the rim-offset , lock at my Krupp ( at the bottom of this page )
You use the rear inner rims as front rims
http://www.customrcmodels.com/Tanks/id86.htm

Forum: Mechanical tech

03-02-2013, 02:03 PM

Replies: 76

Sticky: Driven front axle options?

Views: 95,109

Posted By CustomRCmodels

Re: Driven front axle options?

No cutting required . You just use the male housing (no lip ) part from a straight input/output rear axle and replace that with the non-input/output housing on the TLT-1 axle . Plain simple bolt on .

Forum: Mechanical tech

01-02-2011, 01:10 PM

Replies: 76

Sticky: Driven front axle options?

Views: 95,109

Posted By CustomRCmodels

Re: Driven front axle options?

since I just came across this thread again and it’s a sticky one ,
I figured I add this here :
Example of the use of a TLT-1 axle in one of my 6WD projects:...

Showing results 1 to 5 of 5

Forum Jump

All times are GMT -4. The time now is 12:09 PM.