Quote:
Originally Posted by Snochaser
Scott, that's really nice. I believe I would like one of those! Just something else on the list now.
-Ben
|
Thanks Ben.
Quote:
Originally Posted by J Hall
Well done...I admire you guys that can make models that small work... Any thing smaller than about 1/8 scale is too small for me...
|
Thank you very much. I really enjoy the engineering challenge of getting strength & power out of these little machines.
I improved the bucket curl mounts. The mounts on the prototype loader work fine but, they don't like nice.
This design has more rigidity and protects the servos from getting hit:
With the servo screw heads milled down it allows the two servos (sitting back to back) to fit nicely in the lift assembly and creates a rigid assembly.
I also made beefier aluminum drive hubs. I'll post up pics later when I get the 4-40 screws that I ordered for them.