Quote:
Originally Posted by mog
good job i may have to revisit mine as i was getting too much flex out of the arms when digging. i had filled my arms with epoxy but you brass brace looks like it works better. good work what did you used for a drive esc a sabertooth
http://youtu.be/aExc9opFR0o?list=UUD...mSrl3wlRXoFoBg
|
I do not have any drive esc. I Y-connected the left tires together, and then the right together, and plug them directly into my receiver. The Elevator controls the right side, and the aileron controls the left. I used my controller to mix the two channels together so I can drive straight, and also fully skid like a real Bobcat. I am using an old DX6 Park flyer radio with an AR6000 receiver. Nice work on your conversion. Looks like you had a bit of creep to your drive servo's. It took forever to dial mine in.