I was getting frustrated with messing with landing legs so I temporarily gave up on them to start work on wheel well supports.
They are just set in place for an idea. I think I am going to leave the back end open, possibly some mesh on bottom of frame for storage/wood blocks. Like on some of the 1:1
This is our new safety inspector, he has been doggin me a lot lately, can't find a compromise with keeping shop clean and safe whenever he drops in unannounced.
And after he got done barking safety compliance issues I shrugged them off and went back to work,,,,,,,,,,,,,,,,,,,
Now he really has a bone to pick with me about shop safety. Lol!!!! I harpooned my finger with some sheet metal, pic makes it look bad but it was just a flesh wound and a little tissue, electrical tape, and a good dose of that s$&@ that stings all is well!!
.