Didn't get much done today ... soldering is not my strong point.
Since I was doing it, did the 2 LEDs for the indicators as well as the position lights which will go in the roof of the cabine.
They supply ample wiring and shrink tubing
The resistors are not needed because I use ScaleART's bus system.
Finished product:
After this I painted the outside of the white LEDs black so only the tip has the light come through. (A tip from Christian - aka Newcomer_2). Then couldn't continue with the roof because I had to wait for the paint to dry.
Didn't take pics during soldering. basically, solder red wire to long + of LED. 2 mm shrink tube, then solder black one to the short - of LED, 3mm shrink tubing to go over both, followed by 6mm shrink tubing over the LED. The indicators get a yellow and grey wire instead of a black one so you can keep them apart.
Here the pics of the doors after the filing (as luck would have it, I have a file of exactly the right width):
While I had it all apart some pics of how it fits together. This is really thought out.
Next up the roof and the sun vizor ...