Thread
:
Great Dane excavating co.
View Single Post
#
1184
11-21-2015, 01:00 PM
Cooper
Big Dawg On The Bone
Join Date: Oct 2013
Location: Watsontown, Pa
Posts: 2,119
Re: Great Dane excavating co.
I've been trying to purchase correct dimensional stock alum so I don't have to cut much off. Instead of turning a 4" piece I got 4"X11/2" wall tube. And then turning thin sections for the hub. Welding that to the rim.
I did do a few experimental welds to check penetration and learn how to. It's thick for my Hobart handler 140. I did try to hammer parts apart and held well. And the turning on the lathe didn't dislodge it so I think I'm safe.
And my "hands on" design of how clearances will play,,,
Again no paper design just what's left of my brain and in hand parts!!
I'll be cutting the colored areas once I figure out how to set it up
__________________
Always wasting money, as the wife says.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Cooper
View Public Profile
Find all posts by Cooper