12-13-2015, 05:17 PM
|
|
Big Dawg On The Bone
|
|
Join Date: Dec 2010
Location: South 40 Swamp, Utah
Posts: 2,398
|
|
Re: Great Dane excavating co.
Quote:
Originally Posted by Cooper
Question for you guys, the differential I'm using has x number of teeth on pinion and x number on the big gear. Is that a reduction I should consider into wheel rpm? Like if pinion has 25 teeth and gear has 100 is that a 4:1 reduction? After thinking about this beast and weights wanting to haul, I may be putting motor under cab like 1:1 machines using the reduction gearbox same as the 1:1 machines. Gives me more room in front of axle. Yes over engineering this heavyweight. I've been crunching the numbers and just thought of the differential aspect, I did not figure that into the final rpm. I'll go and count teeth on differential pinion and spur gear and find out numbers. Thanks guys.
|
Yes that's 4:1 ratio.
Cheers!
|