Thread: Nylint michigan crane conversion, hopefully
View Single Post
  #17  
Old 09-11-2016, 07:02 PM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
  
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: Nylint michigan crane conversion, hopefully
Shafts for the pulleys you mean? I used 1/8" steel round from the "hobby" rack at menards. I think you may need to drill out the center hole, I think they were a bit under size but verify.

Jim
Reply With Quote