View Single Post
  #39  
Old 07-15-2018, 04:52 PM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
 
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: 1/16 Oliver Dozer Conversion

Thanks Cooper, I was planning to do some more video today, but I have been struggling with fusion 360 trying to design and print some brackets for the hopper on the short conveyor.

ya, I tried milling off a bit of the leading edge of a few tracks but these little suckers are so small and hard to hold. I just seem to end up cleaning tracks as needed. It is really interesting seeing how good or bad it can be depending on the type and moisture content of the dirt.

PS it just dawned on me and I tried it out in thingiverse, HO Scale, O Scale there is all sorts of stuff that the model train guys have done!

Jim

Last edited by Rvjimd; 07-15-2018 at 09:01 PM.
Reply With Quote