I put new teeth on my digging bucket June 2015, I was noticing the other day how much they've worn... same narrow teeth as the 450 bucket... about 4mm shorter now.
Sharpened them up with the side grinder this morning
Getting the south side soaked up to chimney this week.
North side has been drying the last 10 days, now I can drive on the surface & not gum up my tracks with muddy clay.
Ripped a straight edge.
Start the next cut trying to keep a level bench.
Getting some screening done.
Do some crushing next month, if the lumps are dry enough that it doesn't clog up my crusher plates.
Did some hauling a few days ago, my mod with re-powering the B50 axles didn't work as well as I had hoped, get a lot of weight on the center axle & it still doesn't have enough umf!! to get over the hump. A thought just come to me now... center axle is Slave on the mix, so maybe if I jack it to 120% so center axle pushes harder
... and I need to re-glue my tires to rims with that black tar crap again
, I can see them slipping... yucky stuff to mess with.