View Single Post
  #1729  
Old 03-06-2019, 10:22 AM
Lil Giants's Avatar
Lil Giants Lil Giants is offline
BANNED
 
Join Date: Aug 2010
Location: Saskatchewan
Posts: 4,431
Lil Giants has disabled reputation
Default Re: LilGiantsConstrCo

I spent the weekend carving out the 2nd pass on SE corner



Some problems with the 850 that have been increasing over the last couple weeks... too much freeplay in the swing, erratic power in the tracks & a hydraulic leak... stripped it to a lot pieces yesterday & made a shopping list sent to Frank this morning.

Need a new slip ring












New wiring... green oxidizing on the wires & they're pretty stiff too. Checked resistance, 1 to 2 ohms.







Set screws on pinion gear came loose, but also a lot of side play in the planetary shaft again... gonna try using a 6x15 ball bearing in place of the hard bearing.



But before I take that apart I try to figure out the hyd leak... some where in the front to do with the boom cylinders... either a bad seal on a fitting or a pin hole in one of the lines or ? ...what a greasy mess in a tight area to clean, lots of electrical cleaner, pressurized air & towels








While waiting for parts from Germany, lots of other dirt work to do



big pile of dirt to haul out from SE corner



another pile from NE



I hope to have my track hoe back together in two weeks to dig this up on the east wall



...hope for the arrival of Spring in a month to get busy farming, last yr it didn't come till Arpil 20th, then a mad scramble through May... I hope it comes sooner this yr.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get!

Joe
Reply With Quote