View Single Post
  #16  
Old 02-07-2020, 02:29 PM
crueby crueby is offline
Newbie
 
Join Date: Mar 2019
Posts: 85
crueby is on a distinguished road
Default Re: Cat 340D Excavator build

More done on the main boom, made up the steel plates for each end which will hold the pivot bearings/rods. They were milled out of 303 stainless bar stock and screwed in place.





Still need to do some trimming on the ends.





After that is done, will make up the extension plates at the top of the outer boom that the hydraulic cylinder attaches to, and make up the pivot rod bearings.
Reply With Quote