[tessen]

reinforcements at the tip of the arm



and the look of the set presented


the following is the joining of the hydraulics ram in the boom, I use a piece of brass and I will mechanize it to shape




this is the set presented



The next piece makes the pivot point of the pistons that move the arm, this piece is taken out of casting brass


Another thing I have done is accentuate the detail of the welds on both the sides of the machine, using copper wire and solder




and one of the last steps would be to fill as previously mentioned with resin and filler to give more rigidity to the set, filling gaps and fixing some internal parts


and here once the resin dries



and finally I show you the anchoring of the counterweight, given the weight of this part I had to devise a way to assemble and disassemble, the machine will be too heavy, I need to subtract weight to be able to transport it more easily and for maintenance labours . The system is relatively simple. I leave you some photos and a small video of the operation






https://www.youtube.com/watch?v=2aPF...ature=youtu.be