Yes, i'm running this machine on a Flysky FS-I6 that has had the 'throttle' stick swapped to another 'centering' stick. Mostly all i've accomplished so far is to bang my head against this radio, or annoy others with the beeping.
Good call, Elevon mixing would atleast make setup a whole lot easier.
https://youtu.be/nGmpcT9KdSs
I think doing this is probably about what i had in mind, although it uses all 3 mixes.
https://youtu.be/UQGMdmUp09Y
Following the lower video, this setup looks something like.
Door servo Ch 6
Motor Escs on Ch 2 & 5.
Ch 5 switch assign None
Mix 1
Master. 2
Sl......... 5
Pos. 100
Neg. 100
Offset. 0
Mix 2
Master. 2
Sl....... . 1
Pos. 50
Neg. 50
Offset 0
Mix 3
Master. 1
Sl......... 5
Pos. -50
Neg. -50
Offset. 0
Mix 2&3 run a ratio lower than ch 1, so Full stick is 50% throw
But i need to adjust 1 esc opposite or rewire motor. Doing channel Reverse would have a Hi and Low esc power split
- -
Uh, allegedly i might be 'an Airplane guy', but definately not *that* type.