The new Igaging EZ-View Plus scales use a different protocol than their older DigiMag scales did. I know Yuri is working on it but I'm not sure if he's got his Touch DRO working with that protocol yet.
I got the 3D design done done for the lathe scales and printed the parts out last night.
The 2 parts that I couldn't design any adjustment into are the ones that don't fit. Turns out it was operator error, I didn't model them correctly. I fixed the models and the parts are re-printing now, they should be done in a couple of hours. Then I can start installing the new scales.
After that, about the only thing left for Sherline modifications are new headstock bearings, which arrived in the mail today.