Thread: Mack M75SX
View Single Post
  #82  
Old 03-27-2011, 07:27 PM
ihbuilder's Avatar
ihbuilder ihbuilder is offline
Fabrication and design , super moderator
  
Join Date: Aug 2010
Location: in a cage in Auburn,PA
Posts: 3,557
ihbuilder is a jewel in the roughihbuilder is a jewel in the roughihbuilder is a jewel in the roughihbuilder is a jewel in the rough
Default Re: Mack M75SX
Steve , here's the pinion http://store.rc4wd.com/HPI-Racing-Be...1-_p_1377.html

the rest I got off ebay same as what I have in the pan only I made the axle housing for the truck . Here's a listing http://cgi.ebay.com/HPI-Savage-X-25-...item2eb3d51c69 Oh yes everything lines up thank gawd I didn't want to do it all over I still have to make the axle shafts . I may take the cups off the diffs and run the axle shaft right in . This what the cups look like http://cgi.ebay.com/HPI-86864-Differ...#ht_4874wt_872 they go into the spool and you slide a pin through the end then the bevel gear goes over top .

mike , your looking at the rear axle components . axle housing done on the lathe

thanks Clyde
__________________
RIP FreddyGearDrive 2-12-59/12-19-11

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Last edited by ihbuilder; 03-27-2011 at 07:35 PM.
Reply With Quote