Re: Old School Peterbilt - First Build - lots of photos
Thank you - I think. The selection is mind boggling. Any hint on which I should be looking at? I was thinking this one:
Drill Quantity - Individual Drills
Metric Drill Size - 2.5 mm (.0984")
Drill Bit Style - Short–Length Drill Bits
Drilling Depth - 9 mm
Short-Length Drill Bits - General Purpose
Drill Bit Composition - High-Speed Steel
Surface Treatment - Black-Oxide
Flute Type - Standard
Point Angle - 135°
Point Style - Split
Overall Length - 43 mm
Flute Length - 14 mm
Shank Type - Straight
Specifications Met - Not Rated
Note - The shank diameter is the same or slightly smaller than the drill bit size.
Short length for less breakage - other than that pretty standard. Look OK?
When it comes to the taps I am totally lost. Advice? Thanks!
__________________
Michael also known as "The Crimson Corsair"
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Last edited by CrimsonCorsair; 08-10-2011 at 07:42 AM.
Reason: Easier to read
|