Well I finnished harvest a few hrs ago, I wish I had another 1000ac to do yet, I luv running my CR9060, barely broke it in @just over 100 seperator hrs.
So yeah, perhaps this wkend I'll make some movies with the HK.
The track motors are very weak, the slightest bit of dirt in the links stalls them out! I positioned the arm perpendicular to the tracks to lift the stall track & while moving the track for/rev, slap the bottom of it with my hand to clean the debris out of the links.
One other thing that seems very odd. I'm using 10W hyd oil, the pump strains somewhat for a few minutes of operation while I'm using it, it seems the oil has to warm up some before the pump motor mellows & flows the oil smoothly to the cyls. I'm using the same oil in my 850, no hesitation from the word go. But then the 850's motor to pump connection is a 1:2.5 belt drive (I didn't actually measure it) instead of the HK's direct connection.