Re: Tournarocker Diversion Build
Great progress! I take it your mill is CNC? I don't see a rotary indexing table in the photo, taken during the undercutting picture or hole drilling process.
How hard was it to set up your gear mesh? I'm kind of curious how you went about it. Looks like you took some measurements off the granite table and adjusted the shims under the gear till the mesh was perfect. Then bored the holes in the gearbox to get it right on.
I like how you share photos of the machining process. Helps newbies, like me, learn some new things.
__________________
Nathan
|