Re: Let The Build Begin!
Will that be a set screw with a long rod that will reach through into the other side of the hub for support on both sides of the motor shaft?
Something else while looking at your CAD from the vertical view... is your hub/wheel flush to the face of the gear head, as in a flat solid wall of material?
The reason why I ask is that there should be some recess area so dirt/sand is free to fall out of the inner wheel, and not cause any unnecessary wear or binding. I hope that makes sense.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get!
Joe
|