Thread
:
STX conversion
View Single Post
#
9
12-25-2011, 06:27 PM
ihbuilder
Fabrication and design , super moderator
Join Date: Aug 2010
Location: in a cage in Auburn,PA
Posts: 3,557
Re: STX conversion
still milling parts yet and need some different size screws
. (no bolt place open on Christmas
) I tried to take a pic of the pivot parts being milled , not to good
so I got 1 of the screen
.
I'm using pretty much what Chris did , just going a little bit further with the track frame pivot point . I'm doing away with the single point pivot to the inside of the track frame which would wear over time causing the track frame to come out of alignment thus , alowing the track to come off . the 1's I'm building is similar to the real 1's not as detailed but will function the same .
thanks for lookin
Ben , pic of the insides
__________________
RIP FreddyGearDrive 2-12-59/12-19-11
To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
ihbuilder
View Public Profile
Find all posts by ihbuilder