[Azonic]

I just tryed to drive it for a while, first it was all good forward and back, then i did run only the left track, after that it started to glitch and then it was a little slower then the right one. Im going to try to switch the channels.

No sucsess in changing the channel to another one, same problem, it seem to be some kind of voltage problem, i have run it on the bench and it goes well for a little time, then the CTI module shuts down and i lose contact with the model, if i flip the model switch it goes back in bind mode and i can run it for a little while again, it must be the CTI module that cant handle the voltage from the tracks or something like that. I will try without the CTI module.