Here comes the last pics of the rebuild
First is the difference between the brushless and brushed motors.
I had to grind some grooves on the sides of the transfercase otherwise the steering cylinders didn't went free.
This is the inside of transfercase-cover, as you can se there was plenty of material.
Drivetrain finally in place, not the best looking installation but it works and thats the important thing.
Very steep angle on the rear driveshaft but i think it will work.
There are absolutely no place over.
Wasn't happy with the placement of the soundmodule, so when i thought about it there are very little space in the front. Did som measurements and just maybe it would fit. Sadly i was unable to get it in place as a hole unit so i had to put it in one piece at a time.
Lucky me the SMX is in three parts. Lover circuit board.
Upperside of the upper circuit board, and the aluminium heat shield
Underside of the upper circuit board.
Here it is in very tight space.
Loader back together again,
and it's got a driver.