Thanks Greg , yea your right I could use a good tig welder who has time to weld right now
finished up a little aluminum turning early , pulled the alm chips out and threw in some ss . the result was 2 drive spindles
gotta cut my keyways and drill the 4 screw holes for the ring gear. yea I'm using my trusty ol hpi savage axle parts
I couldn't find good small bevel gears without breaking the piggy bank
. I'll be keying all my shafts on these to eliminate any possible slippage . Designing the track frames and drive housing . going to try to mill them out of solid bar .
---------------------------------------------------------------------------------------
Ahh ,another full week of cussin in the shop