[kingbob]

Thanks Esp, many rounds of putty/sanding/priming/sanding/putty/sanding/priming/sanding to get it that good. Filling every pit and scratch i could find.

Will give the whole thing a 600/800ish sanding before it gets any proper paint. Going to do a test paint on a bit of spare styrene first though.

Next up i'll be fitting the steps, tanks, and toolboxes, obviously needed the body extended and ready so i can get placement right.
Need to trim 10-15mm off the rear end of the chassis rails before mounting the light plate too.

I suppose i better start soldering up some LEDs soon too.