Thread: Converting a POT switch on a radio?
View Single Post
  #2  
Old 04-02-2013, 04:27 PM
pumptech's Avatar
pumptech pumptech is offline
Wannabe
  
Join Date: Oct 2010
Location: Tuscaloosa,Al
Posts: 357
pumptech is on a distinguished road
Default Re: Converting a POT switch on a radio?
Quote:
Originally Posted by rockNmayhem View Post
Ok, this is a quick question for all you electrical guru's out there. I'm wanting to convert two channels on my radio that are all ready dials or potentiometers on the top of it into a couple of momentary on-off-on switches for another use I have for them. I am looking at the wires and cannot figure out what to wire where. If anyone could help me I would greatly appreciate it.

I know this is kinda vague but I'm trying to modify my Turnigy 9x a bit to make the two top dials work for different outputs for a project I have in the works. I'm kinda thinking it will be wired along the lines of the radios from the RC4WD excavator with the levers on the top that are basically momentary 3pos switches I assume.

Any help from you guys would be appreciated.

Thanks,
Tyler
Hey Tyler ,this may be of some help ,fixed a coulpe of atv winches with momentary rocker switches using this diagram ,pic to follow ,the wiring should be close to the same .
Good luck with it
Attached Images
File Type: jpg How-To1.jpg (43.0 KB, 17 views)
__________________

To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.


To view links or images in signatures your post count must be 10 or greater. You currently have 0 posts.
Reply With Quote