View Single Post
  #172  
Old 10-18-2010, 05:43 PM
dirtpusher9's Avatar
dirtpusher9 dirtpusher9 is offline
Moderator
 
Join Date: Aug 2010
Location: Texas
Posts: 457
dirtpusher9 has a spectacular aura aboutdirtpusher9 has a spectacular aura about
Default Re: D9R and 463 pull scraper

Thank you guys.

It will cut about a 1/2'' at a time but that is because the cylinder bottoms out. However after today it may get new cylinders that will dig a little deeper.

Been going to try and build some cylinders for about 2 years now, well today I successfully made one and put it on the scraper. The crowd cylinder that I bought was a 6'' stoke and I needed 7'' so I hooked it up and it works really well. I was wanting the crowd to move faster as well so I put a big ram in it and it doubled the speed of the crowd. I'll get better pics up of it all tore down, it is totally rebuildable through the gland end.

__________________
Joe
Reply With Quote