Started on V2 of the dolly system today:
Nope, not a 4cyl. model engine
Just like the last version, I'm modifying an RCP Crawlers TLT Straight Axle adapter so I can service the outer section easily. This time it will mount cleaner to the frame via screws.
The axle housing will mount to the plate with counter-sunk screws and then the plate will bolt to the frame. Probably hex heads to make it look 1:1.
Bolted up to the wheel
Went with 2.2s this time. After looking at the video closer, the 1.9s were too small.
Who needs a laser/water jet? Bandsaw, grinder, and file son! (Except for that whole need to make 3 more part
)
