Hi guys, I've been on a bit of a roll lately, and I whipped up some transfer case mounts for the Wedico! Now I have a nice way to mount up the t-case and I can continue working on the rest of the driveline. There isn't much left to do, but get the driveshaft lengths figured out, and figure out the permanent mounting location of the trans.
Here is a picture of the transfer case and it's new mounts.
I'm still sliding things around in the chassis, but the transfer case is practically guarenteed to be sitting where it is in these pictures. I just need to drill some holes through the frame rails and bolt her up!
Things are starting to come together, and space is getting tight! I still need a way to operate my lift axle and I was thinking of using a servo, but it will take a little creativity to fit one in now, and it will most likely require some more custom machined parts! That's all for now. Thanks for looking.