[Lil Giants]

Kordell, here's Joe's build thread of the D9 with lots of pics.
http://www.rctruckandconstruction.co...tpusher9+dozer

I wish I would have had this big daddy 850 when I started the basement excavation Greg, would have been a lot more fun than swinging a pic axe for the 1st 20cu yd.

I got my RCP57 gravel boxes on Friday, one for the green GL & the other is for the pup trl it will pull. These boxes are as described, direct bolt on to existing stock Tamiya holes in the frame, solder the motor wires & run them up to an esc & you're good to go!











You got the length I requested Reg dead on, I didn't need to slide it back at all.







Now to get busy with the pup... not a lot to do, but making my own beefy pintle loop & hook will take some time.