Thread: Nylint michigan crane conversion, hopefully
View Single Post
  #25  
Old 08-30-2016, 09:06 AM
Rvjimd's Avatar
Rvjimd Rvjimd is offline
Craftsman
  
Join Date: Dec 2012
Location: Des Moines, Iowa
Posts: 884
Rvjimd is on a distinguished road
Default Re: Nylint michigan crane conversion, hopefully
How about like this? I'm about to drill the horn to the drum. Then it can be screwed to the servo through the center hole in the drum. The off side can then use a pin to support it.



Jim
Reply With Quote