If I don't split this into multiple posts, the forum page is going to end up miles long and very bandwidth heavy.
7 chamber taillights using 1206 SMD LEDs.
With license plate light
Prototype for the high mounted taillights. Taillight + brake light in the LED ring and turn signal in the middle with fiber optics and 5mm LEDs.
New old style headlights. 1mm and 0.5mm styrene.
Back of right headlight unit with improvised heat sink for the main light. Orange 1206 and warm white 2835 LEDs.
I'm building a light and servo controller around an Arduino Mega. This is a system testing interface panel for switching lights and checking the state of the controller.
interface panel demo:
https://www.youtube.com/watch?v=cbddWVinL7c
2x 3528 blue LEDs on each side of the grille
1mm holes through the grille and a small piece of clear plastic
Front emergency lights demo
https://www.youtube.com/watch?v=kBJakXZSqis