[avel]

Well I did it. I sprayed the silicone lubricant on the tracks and am waiting for it to dry completely. Earlier this morning I was modifying my transmitter.

First I tucked the antenna inside.



Then I replaced the annoying speaker with a red LED. Just soldered it in, nothing fancy.


Ok the tracks. I washed and dried them and then placed them on some tape with the sticky side up.



Here is the silicone lubricant I used, picked it up at Home Depot.


Here are the tracks after being sprayed and drying for about 2 hours. Also I held the board upside down for awhile and tilted it in different directions. I put on too many coats at once.



About the sanding, I kind of enjoy that kind of "work". Anyway I am tiiiired, hopefully more updates tomorrow.