Thread: CAT D11R-CD
View Single Post
  #6  
Old 07-03-2011, 10:58 PM
DozerMan DozerMan is offline
Newbie
 
Join Date: Jun 2011
Posts: 4
DozerMan is on a distinguished road
Default Re: CAT D11R-CD

Quote:
Originally Posted by edwalsh18 View Post
what scale are you going for? what do you have planned for drive motors? what about hydraulics? so far its looking good! dont be stingy with the pics share them i am sure i speak for everyone when i say we love visuals (videos work too) i am still preparing to build a d11. not sure which scale now. the deciding factor for me will be what i can get for drive motor and tracks and make it fit for a low cost. starting to think i might have to make the tracks completely from scratch.

thanks for posting! keep on it, very interested to see how it turns out!
i am torn between Hydraulics or Electric gear motors. i would love to be able to run it for as long as i want without having to charge massive batteries. and i know little about hydraulics (even though i did a 6 month course on them! )
not to mention i would need to find a motor and pump to fit inside it along with 2 motors and controls..

as for the hydraulics for the ripper and blade i was thinking of using electric screw type rams. unless i use real hydros

it looks to be close to 1/8.4 scale.

49.2" 1250mm L
19.6" 500mm H
15.1 385mm W (not including blade)
22" 560mm W (blade width)

Last edited by DozerMan; 07-03-2011 at 11:06 PM.
Reply With Quote