View Single Post
  #10  
Old 12-28-2011, 01:59 PM
Vanisle Vanisle is offline
Green Horn
 
Join Date: Oct 2010
Location: Vancouver Island
Posts: 156
Vanisle is on a distinguished road
Default Re: UMS Gear Pump Belt Drive Conversion

I ended up stripping the inside of the drive gear so never got this going. I am not sure what the problem was but I think the original hole was slightly off center so it didnt quite line up with my lathe centered hole on the bronze bushing. I have been experimenting with some other gears I have but so far haven't had success (for other reasons). Defintely easier just to buy a pump but I am not quite ready to give up yet.
Reply With Quote