Today, after doing a few things I needed to do, I started the Weyerhauser Logging truck conversion. I didn't get too far along on it, but it's a start. I got as far as chopping off the sleeper, adjusting the width of the previously rear panel/access door on the sleeper, & marking out where I intend to place the rear window.
unnamed (48) by
Anthony Kalnoski, on Flickr
The hardware was previously used for open/close the access panel.......it's only there temporary, until I get everything sorted. Once things are ready to be glued in place, I'll remove them, & patch their holes.
unnamed (50) by
Anthony Kalnoski, on Flickr
I took 5CM out of the center(ish) to make the panel fit it's new home.
unnamed (49) by
Anthony Kalnoski, on Flickr