Quote:
Originally Posted by frizzen
Which welding method are you using?
|
It's a pulsed tig.
Originated at jewellers and dental technicians.
-----------
During a former Project i've built a hydraulic cylinder. The car isn't run anymore so i've used the cylinders body again. A hydraulic steering needs piston rods in both directions.
I convert it from
to
For scale it is way to big, but i need the diameter to get enough pressure for steering.
Parallel the work on the trough begins
the rough form is easy
but the typical beads are an enormous bulk of work
an intermediate result
-----
50 kg / 110 lbs total weight? A usual 540 motor will be a bit overwhelmed.
From a kind hobby colleague I've get two big 24v motors with very tough planetary gearboxes.
side by side with a usual 540 with planetary gearbox