Thread: JBC limited NZ
View Single Post
  #346  
Old 11-14-2015, 01:56 AM
Lil Giants's Avatar
Lil Giants Lil Giants is offline
BANNED
  
Join Date: Aug 2010
Location: Saskatchewan
Posts: 4,431
Lil Giants has disabled reputation
Default Re: JBC limited NZ
DAGNABBIT ANDY


I KNEW I was over thinking this!!!

I like your idea muuuch better! much simpler, less moving parts & it looks like the Alpine cutter Neil posted a vid of.

So what's the rpm of this motor gearhead & where did you get it? To go higher rpm = less torque What about just going with a bit bigger diameter sprocket?

And I really like how you attached the sprockets at an angle... Genius!

My grinder is going in the bin & I'm building one like this.
__________________
Sharing knowledge is one thing that defies basic arithmetic logic --- the more you share, the more you get!

Joe
Reply With Quote